Installation Steps Of Floor Heating Water Separator

1. Connect the water inlet and outlet: first connect the water inlet and outlet of each loop heating pipe to the water distributor and water collector respectively.
2. Corresponding installation of valves: Valves, filters and drain pipes should be installed along the direction of water flow on the water supply connection pipe before the water separator.
3. Set up bypass: A bypass pipe should be installed between the main water inlet pipe of the water separator and the main water outlet pipe of the water collector, and a valve should be set on the bypass pipe.
4. Set manual or automatic exhaust valves: Manual or automatic exhaust valves should be installed on the water distributor and water collector, and automatic air release valves should be installed as much as possible.